[Clayart] Controllers

Ken Chase kchase235 at gmail.com
Tue Jul 19 20:36:35 EDT 2016


Thanks Jim:
I spoke to tech support today and he explained how to pre-heat. Actually easy. I guess this is
Key in bisque firing. Would this principle still apply when glazing?
Best,
Ken

Sent from my iPad

> On Jul 19, 2016, at 12:43 PM, Jim Brown <jbrown1000 at gmail.com> wrote:
> 
> Ken, never saw a controller before but lady asked me if I knew how to
> change the one she was using.  Sat down in front of it and went through the
> program she was using and figured out what she wanted.  After a couple of
> tries, figured out how to put in new program.
> 
> Next day she brought in the manual and after reading through it could then
> plan any program one could want.
> 
> Don't know what controller you have but there should be a pre-heat program
> already in it - if not, shame on them.  I don't know of anyone that does
> not slowly bring the heat up or leave on low overnight - just plain good
> horse sense.
> 
> At last resort, you CAN start a program, let it run for a while to bring
> temp up to around 190 or so and then stop it, start it all over again.
> That would be a pain but would be last resort.
> 
> 
> *                       JIM BROWN*
> 
> *                 BROWN POTTERS*
> 
> *  "Making handmade pottery . . . *
> 
> *                                                . . . since the 1700's"  *
>                   *   386 479-4515*
> *            www.brownpotters.com <http://www.brownpotters.com>*
> -------------- next part --------------
> An HTML attachment was scrubbed...
> URL: <http://lists.clayartworld.com/pipermail/clayart/attachments/20160719/823b328c/attachment.html>
> 



More information about the Clayart mailing list