[Clayart] Electrical technical

[wschran at twc.com]

Every thing I've read from every kiln manufacturer specifies only
using copper wire for kilns.Is this aluminum you write about the
conduit to run electric lines through or the wiring for the kiln?

Bill

William Schran wschran at twc.com 703-505-1617

	-----------------------------------------From: "Taylor Hendrix" 
To: "Clayart posting"
Cc: 
Sent: Tuesday August 27 2019 6:39:15PM
Subject: [Clayart] Electrical technical

I have just run in-ground feeders to the panel in my new studio space.
4
 inch conduit, 250 KCL aluminum stuff. Stiff as (figure that one out.)
No
 electrician. None. Me. Me. Me. Couldn't afford it otherwise. Already
have
 two 20A circuits, ac unit, and a light working great.

 Electricians my ass. Those of you who have done your own, piss off.
Those
 of you who have not, be awed.

 Snakes, liquor, and whatnot,

 Taylor
 -------------- next part --------------
 An HTML attachment was scrubbed...
 URL:
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.clayartworld.com/pipermail/clayart/attachments/20190828/34ff9c89/attachment.html>